The E2000 is DJI's first advanced propulsion system designed specifically for industrial applications and aerial imagery. Combining the 6010 motors, ESC 1240S / X field-controlled electronic speed controllers and R2170 propellers, the E2000 is designed to carry loads of 1,800 to 2,500 g per axle, advanced imaging equipment.
| Max Thrust | 5100 g/rotor (50 V,Sea Level) |
|---|---|
| Takeoff Weight Recommended | 1800~ 2500 g/rotor (Sea Level) |
| Battery Recommended | 12S LiPo |
| Working Temperature | -10°C ~ 50°C |
| Stator Size | 60×10 mm |
|---|---|
| KV | 130 rpm/V |
| Weight | 250 g |
| Max Allowable Voltage | 52.2 V |
|---|---|
| Max Allowable Current (Persistent) | 25 A |
| Signal Frequency | 30 Hz ~ 450 Hz |
| Battery | 8S~12S LiPo |
| Size | 85 x 44 x 18 mm |
| Cable length | 600 mm |
| Weight (with Cable) | 90 g |
| Weight (without Cable) | 55 g |
| Diameter / Thread Pitch | 53.3 x 17.8 cm（21 x 7 inch） |
|---|---|
| Weight (two propellers) | 40g |
The data above was measured with an input voltage of 44.4 V, at room temperature and sea level. The thrust was adjusted by the throttle.
η – Motor Efficiency, T – Thrust, I – Current, P – Input Power
The data above was measured with an input voltage of 44.4 V, at room temperature and sea level. The rotational speed was adjusted by the throttle.
The data above was measured at full throttle, at room temperature and sea level.
η – Efficiency, Τ– Torque, I – Current, P – Output Power
The data above was measured with an input voltage of 44.4 V and 100% duty cycle, at room temperature
and sea level. The rotational speed was adjusted by the payload torque.