while that of the Intelligent Flight Battery Plus is 58 W.
[When charging DJI Mini 3 Pro Intelligent Flight Battery]
It will take 64 minutes (without removing the battery from the aircraft).
It will take 57 minutes to fully charge one single battery (using the DJI Mini 3 Pro Two-Way Charging Hub).
[When charging DJI Mini 3 Pro Intelligent Flight Battery Plus]
It will take 101 minutes (without removing the battery from the aircraft).
It will take 77 minutes to fully charge one single battery (using the DJI Mini 3 Pro Two-Way Charging Hub).
Note: When charging a battery without removing it from an aircraft, the heating up issue of the aircraft will cause power reduction, slowing down the charging rate.
DJI Mini 3 Pro Intelligent Flight Battery lasts 34 minutes, while DJI Mini 3 Pro Intelligent Flight Battery Plus lasts 47 minutes.
Note: Intelligent Flight Battery Plus needs to be purchased separately. If used with this type of battery, the takeoff weight of the aircraft will be more than 249 g. Please find out and follow the local drone flying laws and regulations before a flight.
2. Go to “Safety” and ”Advanced Settings” in DJI Fly, and then set “Emergency Propeller Stop” to “Emergency Only”. Then during flight, when the flight controller determines that there is an error with the aircraft, keep pushing both control sticks to the inner or outer corners for 1.5s and the motors can stop.
If used with DJI Mini 3 Pro Intelligent Flight Battery, and the Payload mode is enabled, the maximum service ceiling above sea level is 1,500 m. If used with DJI Mini 3 Pro Intelligent Flight Battery Plus, the propeller guards are not recommended to be used, because the propulsion performance may be affected by the increased takeoff weight.
Type of Motor: Brushless
Diameter: 18 mm
KV: 2824 rpm/V
Rotation Speed While Hovering (Rated Operating Voltage): 6040 rpm
Maximum Rotation Speed (Rated Operating Voltage): 10700 rpm
Rated Output Power of One Single Motor: 3.71 W
Maximum Output Power of One Single Motor: 22.3 W
Rated Operating Voltage of One Single Motor: 7.4 V
Distance between the installation positions of two screws on a motor: Approx. 1 cm
If a vehicle/boat is set as a tracking subject, the distance between the aircraft and the subject should be 6 to 100 m, and the altitude be 6 to 100 m. (Note: The recommended distance is 20 to 50 m and the recommended altitude is 10 to 50 m.)
If the aircraft starts to follow the subject, but the distance between the aircraft and target is not in the range of abovementioned distance or altitude, the aircraft will automatically fly into the supporting range. If the aircraft flies in the range of recommended distance and altitude, you will have a better experience of tracking.
2. When the flight mode is switched from N/C mode to S mode: The aircraft will not brake and its flight speed will not decrease.
2. Update the firmware using DJI Assistant 2. For downloading DJI Assistant 2, please go to the corresponding downloads page of the DJI official website.
Note: Please do not remove the intelligent flight battery from the aircraft when updating the firmware of the battery. The firmware of the battery will be updated together with that of the aircraft.
You can download the DJI Fly app from major application stores (except Google Play) or from the Downloads page on the DJI official website. Please check the compatibility device list on the website.
The downward infrared sensing system is used for flight altitude measuring.
Bypass: The aircraft will automatically change and plan a new flight path to bypass the obstacle if it detects an obstacle. If the obstacle cannot be bypassed, the aircraft will brake and hover in place.
Break: If sensing any obstacle in this mode, the aircraft will brake and hover in place.
It is not recommended to fly an aircraft within 10 meters above water.
Please refer to information on the specs page of DJI’s official website, or in the User Manual.
Do not use the old propellers again. Note to replace the pair of propellers instead of one single propeller.
b. Stop other apps from running in the background on your mobile device.
c. Keep an eye on the antennas during flight, and keep the antennas facing the position of the aircraft.
DJI Mini 3 Pro ND Filters Set (ND 16/64/256)
4K: 2× (Note: The zoom function is not available if recording 4K 48/50/60 fps videos.)
2× (Note: The zoom function is not available if capturing 48MP photos.)
For iOS users, there is a charging phone option in the DJI Fly app for iOS v1.4.8, which can be enabled or disabled.
Make sure to operate the aircraft in an open area. Tall metal structures, mountains, rocks, and forests may interfere with the aircraft's compass and GPS signals.
In order to prevent the remote controller from interfering with other wireless devices, be sure to turn off other wireless devices before using the remote controller.
Do not fly in the vicinity of a source of electromagnetic interference. Sources of electromagnetic interference include but are not limited to: Wi-Fi hotspots, routers, Bluetooth devices, high-voltage wires, high-voltage power transmission stations, mobile phone base stations, and television broadcast signal towers.
b. Close other running programs in the background of the mobile device.
c. Pay attention to the direction of the antenna. Please adjust the plane of the antenna facing the position of the aircraft.